1967 FARREL 5-AXIS CNC GANTRY

Manufacturer: FARREL
Model: 5-Axis CNC Gantry
Year: 1967
Table Dia.: 396"
Swing: 420"
Under Rail: 240"
Capacity: 500 Ton
RPM: 11
Motor: 150 HP
Control: AB
Price: SOLD!  

                 
FARREL 33’ 5-Axis CNC Gantry Type Vertical Boring Mill
                 
Built in 1967 – Out of Service from 1980 to 1989
                 
ALLEN BRADLEY Model 8600 CNC Control - Installed in 1995
                 
WITH LIVE SPINDLES ON BOTH RAM HEADS
                 
Table Diameter: 33’ (10,000 MM)
                 
Maximum Distance Between Columns: 35’ (10,668 MM)
                 
Vertical Travel of Cross Rail on Columns: 18’9”
                 
Vertical Travel of Rams: 14’3”
                 
Cross Travel of Each Ram Head on Rail: 32’7”
                 
Distance From Table to Bottom of Ram: 25’1” Max. (7,645 MM)(Cross Rail Up – Ram Retracted)
                 
6’4” Min. (Cross Rail Down – Ram Retracted)
                 
Longitudinal Travel of Gantry on Bed Ways: 66’
                 
Table Speeds: Constant Torque: .2 to 2.8 RPM; Constant Horsepower: 2.7 to 11 RPM
                 
Table Load Capacity – Uniformly Distributed: 500 Tons
                 
Vertical Travel of Ram Spindle: 4’
                 
Dimensions of (2) Ram Heads: 28” Square
                 
Taper in Live Spindle Heads: No. 7 M.T.
                 
Diameter of Live Spindles: 8”
                 
Speed Range on Live Spindles: 2.5 to 400 RPM
                 
Feed Rates to Rams: .015 to 50 IPM
                 
Traverse Rate to Gantry: 150 IPM
                 
Traverse Rate of Cross Rail: 11-1/2 IPM
                 
Table Has Indexing or Milling Capabilities
                 
Motor: 150 HP Vari-Voltage Table Drive and Complete Electrics
                 
Overall Height From Floor to Top of Rams: 48’9”
                 
Complete With: Hydrostatic Bearing Surfaces for Table and Columns Along Bed Ways; (2) Vertical Ram Head With Live Spindles; Right Angle Attachment for
                 
Either Ram
                 
Head with No. 50 Taper; Allen Bradley Model 8600 CNC Control
                 
Available at Extra Cost: (10) 8’ x 12’ x 1’ T-Slotted Floor Plates, T-Slots on 24” Centers
                 
The gantry will operate on parallel machined runways, providing access to the 33’ diameter vertical boring mill table and perform the operations usually done on a horizontal as well as a vertical boring mill.
                 
                 
INSPECT UNDER POWER! VIDEO AVAILABLE!